A profile flush with the plaster, with no trim and no visible screws. Inside runs a safe 48 volt supply; on top you mount spotlights and linear modules, and you move them whenever the layout changes. No rewiring, no chases to close: the project stays free to change its mind.
Extra low safety voltage: you can move a spotlight with the system switched on, with no risk and without calling an electrician.
The track finishes into the plaster, two centimetres wide: the hardware vanishes and only the line of light is left.
Bars cut to size, L, T and X joints, power feeds and end caps: the layout follows the plan. One more branch can be added later on.
Adjustable spotlights and 560 mm linear modules live on the same track, shortened 3 cm at a time to reach right into the corner. Dimmable, flicker free.
The profile is buried in the plasterboard and finished flush: the track is nowhere to be seen, only the light is.
Fixed straight to the ceiling where recessing is not an option, with the same clean lines and the same end caps.
Hung on adjustable wires to bring the light down over a table, a counter or a display island.
The configurator lays out bars, joints and luminaires, checks the loads and hands you the parts list, ready to quote.
Open the configurator